Signed in as:
filler@godaddy.com
What You Will Need
Rod - Reel - Line
Bobber - Bobber Stop - Beads
Bobber - Bobber Stop - Beads
Recommended for this technique is a fishing rod that is 9'0 - 10'6". Size 35 or 40 reel. Preferably spooled with 20-30lb Braided line (high-vis)
Leader sizes will vary depending on conditions, but we typically make sure to have between 8-15lb of fluorocarbon or monofilament when float fishing with a bobber and jig, roe, or beads
Bobber - Bobber Stop - Beads
Bobber - Bobber Stop - Beads
Bobber - Bobber Stop - Beads
There are a variety of bobbers on the market. Recommended are the torpedo style bobbers. The important part is to make sure that your in-line weight and jig weight combined do not exceed the capacity of the bobber.
Weight / Swivel
Bobber - Bobber Stop - Beads
Weight / Swivel
An in-line weight, which has a built in swivel are ideal for this type of fishing. Having a selection of sizes is recommended for fishing different water conditions.
Leader
Leader
Weight / Swivel
As mentioned above, the size of leader used is dependent on the water conditions and the size of fish in your area. Low and clear conditions may call for a lighter setup. High and dirty conditions will allow you to fish bigger and heavier gear.
Jig
Leader
Jig
We typically fish 1/8oz and 1/4oz jigs with this float fishing rig. With the wide selection that is available, We recommend picking up a couple colors that you'd like to try. You will find what you like and what works best for you as you gain more experience using a bobber and jig
Step 1
Setting Up Your Bobber
With your rod assembled, we will first be working with your main line. Regardless of the style of bobber stop you are using, this will be the first thing that we slide onto our line. Sliding it far enough up your line to be out of your way. You will then want to add a 4mm bead above and below your bobber. (you can clip your bobber stop tags but be sure to leave enough to be able to retighten and readjust your knot when and if needed) Your bobber stop is used to adjust the depth that you are fishing. The further you slide your stop up your line, the deeper your rig will be in the water.
Step 2
Adding Weight
With our bobber set up, we can now tie our weight to our mainline.
There are a wide variety of knots, we recommend using a knot that you know and trust. When using braid, I typically use a Uni knot.
On either side of the in-line weight there is an eyelet. You can tie to either eyelet.
Step 3
Adding A Leader
Many say that Steelhead are more line shy than Salmon are, so choosing your leader size is an important factor when setting up this rig.
8lb - 12lb is pretty typical, but again this can be adjusted higher or lower. I go a bit on the heavier side at times and use a 15lb up to 18lb.
Always Check Regulations for the area you'll be fishing when choosing your leader length. 18"-24" is a pretty common theme from me.
With our braid tied to one side of the in-line weight, a leader can now be tied to the other eyelet.
Again, use a knot you know and trust. I typically use a clinch knot here for this float fishing setup
Step 4
Tying On A Jig
There is no magic here on the business end, just a knot to attach your jig.
As for all knots, you want to know it's going to hold, so this isn't the best time to try out a new fishing knot. Go with what you know and trust. I normally use a clinch knot here as well.